Ashland Fabricating and Welding can supply the following plate & sheet in raw form or fabricated to your specifications.
• Grades: A1011, A36, AR400, A572 grade 50, T1
Hot Rolled Sheet:
Thickness: 7 GA - 16 GA
Size: 4' x 8' - 6' x 12'
Hot Rolled Plate:
Thickness: 3/16” - 6”
Size: 4' x 8' - 8' x 24'
Cold Rolled Sheet:
Thickness: 10 GA - 22 GA Sheet
Size: 4' x 8' - 6' x 12'
Floor Plate (Safety Plate):
Thickness: 14 GA - 1/4”
Size: 4' x 8' - 8' x 20'
Ashland Fabricating and Welding offers beams ranging from 3” to 24” in width.
S Beams: Standard
W Beams: Wide Flange
M Beams: JR., H or Light Beams
• Tees are available in 20 ft stock lengths at various widths.
• Channels are available in Bar, Standard, Structural, MC and Jr. sizes. They range from 3/4” up to 24” and are available in various lengths.
• Angles are available in 1/2” to 8” leg length, varying thickness.
Ashland Fabricating and Welding stocks a large variety of bars in varying sizes and widths.
Hot Roll Flat Bar:
Size in inches: 1/8” - 3” various widths
Hot Roll Round Bar:
Size in inches: 1/4” - 4”
Hot Rolled Squares:
Size in inches: 3/8” - 4”
Reinforcing Bars:
Inch Pound Bar Size: #3 - #18
Diameter: .375" - 2.257"
Cold Finish Bar Rounds:
Size in inches: 1/8” - 6 1/2”
Cold Finish Flat Bar:
Size in inches: 1/8” - 6”
Square Tube:
Size in inches: 3/8” - 10”
Rectangular Tube:
Size in inches: 1” - 16”
• Cold Dawn Seamless - offers good surface quality and increased mechanical properties over hot finished seamless tubing.
• Hot Finished Seamless - applicable where precise dimensions and surface quality are secondary.
• Welded D.O. - cold drawn ERW Tube, all flash removed. Uniform and precise it is preferred over seamless.
• Electric Resistance Welded - produced from low carbon steel comes in “as welded condition”. Different degrees of flash removal based on size.
• Cold Drawn Butt Welded - produced from ERW hollows. Not for use in pressure applications.
• Hollow Structural Tubing - produced in square, rectangular and round shapes. Can be used in most types of fabrication, including welding, bending, and flattening.
• Available Sizes: 3/4” to 16”, varying thickness.
(Galvanized tube and pipe available)